Guest - Not logged in | ||||||||||||||||||
Reviews > Sleep Gear > Accessories > Millair Company Instaflator > Owner Review by Ray Estrella
Millair Company Instaflator
September 06, 2011
TESTER INFORMATION
I've been backpacking for over 30 years, all over California, Minnesota, and many western states. I hike year-round in all weather, and average 500+ miles (800+ km) per year. I make a point of using lightweight gear, and smaller volume packs. Doubting I can ever be truly UL, I try to be as light as I can yet still be comfortable. I start early and hike hard so as to enjoy the afternoons exploring/chilling. I usually take a freestanding tent and enjoy hot evening meals. If not hiking solo I am usually with my brother-in-law Dave or my twin children. The Product
Manufacturer: Millair Company Quick & Dirty, Nitty Gritty The shortest review I have ever written is also for the least expensive piece of gear I have ever reviewed, and is also one of the things I will never leave for a winter trip without. The Instaflator is hands down the fastest, lightest, and easiest way I have ever found to get air into my sleeping pads. And the fact that it does it without adding moisture is a God-send for backpacking in extreme cold. Read on, it won't take long.;-) Product Description
The Millair Company Instaflator (hereafter called the Instaflator) is merely a tube of proprietary plastic that is gathered at one end and attached to a hard plastic nozzle with an outside diameter of 0.75 in (1.9 mm). There are a couple attached hard plastic adaptors that ca fit onto the end of the tube made to fit the small mouth-valves associated with pool toys, beach balls and such. (I snipped these off as soon as I got it.) To facilitate use with backpacking pads' wider valves the company sends an adaptor made of clear flexible tubing that slides over the Instaflator nozzle and the pad's valve. Below is the Instaflator with tube attached. Operation is quite easy as I shall demonstrate on a Large NeoAir in the Dinkey Lakes Wilderness. Merely unroll the Instaflator and attach it to the open valve on the pad. Now I stretch the Instaflator out to its full length and open the end. If the wind is blowing I can let the tube fill with air by itself. If it is still I just blow one breath into the tube to make the walls open. It fills with air the rest of the way by itself. Now I close the end of the Instaflator and roll the tube down towards the pad. Pushing on it speeds the process but just rolling it up works too. Once the pad is full I pull the Instaflator loose from the valve and close it. That's it! Field Conditions
The only time I took the Instaflator on a 3-season trip was the Dinkey Lakes trip in the photos above. It was great weather at 9000 ft (2740 m) elevation. Observations
As is obvious in my reviews I do a lot of winter backpacking and some winter camping. One of the biggest problems I encounter in winter is inflating my pads. When inflating a pad by mouth a lot of moisture is introduced inside the pad. In very cold temperatures this moisture will freeze inside where it is there to stay until such time as I can get it home and warm to melt the ice crystals and flush the moisture out with dry air. (A process that can take quite a while I might add.) While the added moisture and slowly growing weight of any affected pad is bad enough, as I have switched long ago to down filled pads in winter (see reviews) it is more of a problem as it also compromises functionality. If the moisture reacts with the down before freezing it will cause down to clump negating much of its insulating power. The more it happens the less the pad will insulate. This could be dangerous at the temperatures I (try to) sleep at. Well my worries were unfounded. The Instaflator did awesome for me all last winter (2010/11), including the night at McCarty Lakes in the Paul Bunyan State Forest seen above. The part of Minnesota that I am in is almost always windy so I rarely have to even use the one puff to start the tube expanding. And my winter biggest pad takes only two fill-ups to inflate. (I just ordered a bigger one, maybe I will need three fill-ups, ooh that will be a hardship… not!) At a total weight with adaptor of only 1.7 oz (48.2 g) I would not mind carrying two on a long trip just for redundancy. I could carry three of them and it would still be lighter than my pump-sack. Now while I do not have a problem with it (yet) many of my friends complain about trying to blow up their pads when at high elevation. They complain of "running out of air" and getting dizzy. I let them use, or refer them to, the Instaflator to avoid the lung abuse. The Instaflator is a permanent addition to my winter kit and I really don't expect to ever be without one again. Ray Estrella "I measure happiness with an altimeter" This report was created with the BackpackGearTest.org Report Writer Version 1.5 Copyright 2011. All rights reserved. Read more reviews of Millair Company gear Read more gear reviews by Ray Estrella Reviews > Sleep Gear > Accessories > Millair Company Instaflator > Owner Review by Ray Estrella |